Heating cable DTCE-300 with 30 m PTC thermistor / output 300 W/m at 400V Ready-to-install heating mat with a connecting cable suitable for installation in reinforced concrete, screed or sand bed. With additional protective braiding for use with the FI protective circuit. This heating mat system is particularly suitable for installation in angled and/or large areas, as there is no need to return the second connection. Including factory-fitted waterproof sleeves and a 30 m long PTC thermistor, install according to the system according to the installation instructions. Measure the insulation and total resistance. Heating cable according to IEC 60800, voltage: 400 V, nominal limit temperature: 80°C, specific heating output: 300 W/m2, resistance tolerance: +10% / -5%, minimum installation temperature: 5°C, smallest bending radius: 5 x dA, protection class: IP X7
| Property | Value |
| Length: | 14800 mm |
| Width: | 1000 mm |
| Thickness: | 7.5 mm |
| Connected load: | 4120 W |
| Area: | 14.8 m |
| Power: | 300 W/m |
| Application: | Direct floor heating |
| Heating conductor load: | 30 W/m |
| With carrier mat: | yes |
| Fixation of the Heating conductor: | glued on |
| Number of PTC thermistors: | 1 |
| Length of PTC thermistors: | 30000 mm |
| Suitable for damp rooms: | yes |
| With controller: | no |
| Connection voltage: | 400 V |
| Suitable as roof heating: | no |
| Suitable as open space heating: | yes |
| With floor temperature sensor: | no |
| With room thermostat: | no |
| Self-adhesive: | no |
