Eltako 21100830 dimmer switch EUD12F with mains switch

Universal dimmer switch. Power MOSFET up to 300W. Automatic lamp detection. Standby loss only 0.1 watt. Minimum brightness and dimming speed adjustable. With children's room and snooze function. Series-mounted device for mounting on DIN-EN 60715 TH35 rail. 1 division unit = 18mm wide, 58mm deep. Universal dimmer switch for lamps up to 300W, depending on the ventilation conditions. Dimmable 230V LED lamps and dimmable energy-saving lamps also dependent on the lamp electronics. Zero-crossing switching with soft on and soft off to protect the lamp. Supply and switching voltage 230V. Short control commands switch on/off, permanent control changes the brightness up to the maximum value. Interrupting the control changes the dimming direction. The set brightness level is saved when switched off. In the event of a power failure, the switch position and brightness level are saved and switched on when the supply voltage returns. Automatic electronic overload protection and overtemperature shutdown. With integrated shutdown relay to isolate the switched circuit from the field. The control button(s) are connected to terminals T1 and T2 of the EUD12F (field-free internal direct current) via low-voltage control lines, the permanent 230V power supply directly to an external conductor in front of the FR12-230V field isolation switch. This means that full functionality is retained, but the light supply line is switched to a field-free state by the integrated shutdown relay. Glow lamp current is not permitted. The upper % lamp rotary switch can be used to set the minimum brightness (fully dimmed), e.g. for dimmable energy-saving lamps. Automatic operation allows all types of lamps to be dimmed. The lower dim-speed rotary switch can be used to set the dimming speed in seven stages in automatic mode. +ESL is a comfort position for energy-saving lamps which, due to their design, must be switched on with a higher voltage so that they can be switched on again when dimmed down. -ESL is a comfort position for energy-saving lamps which, due to their design, cannot be switched on again when dimmed down. Memory is therefore switched off in this position. Inductive (wound) transformers must not be used in the +ESL and -ESL positions. In addition, the maximum number of dimmable energy-saving lamps can be lower than in automatic mode due to the design. With children's room switch: When switched on by pressing the button for a longer period, the lamp switches on at the lowest brightness after approx. 1 second and, as long as the button is continued, slowly dims up without changing the last saved brightness level. With snooze function: A double pulse dims the lighting from the current dimming position to the minimum brightness and then switches it off. The maximum dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can therefore be shortened accordingly. You can switch the light off at any time by pressing the button briefly during the dimming process. A long press during the dimming process dims the light up and ends the snooze function. L loads (inductive loads, e.g. wound transformers) and C loads (capacitive loads, e.g. electronic transformers) must not be mixed. R loads (ohmic loads, e.g. 230V incandescent and halogen lamps) can be mixed in as desired. The universal dimmer switch EUD12D in conjunction with the power booster LUD12 is suitable for mixing L loads and C loads.