Wireless card switch wg pure white glossy for surface mounting 84x84x29mm or for mounting in the E-Design65 switch system*. Generates the energy for radio telegrams itself, therefore no connection cable and no standby loss. Smart home sensor. When inserting and removing a hotel door card (hotel card/key card) in the standardized credit card format 86x54mm, a radio telegram is sent to the Eltako building radio. The scope of delivery includes the fully assembled two-part card guide, an R1E frame, a fastening frame, a holding plate and a radio module as well as two screws with dowels. Installation by screwing: First disassemble the fully assembled card switch. To do this, remove the screw, unhook the card guide and remove the intermediate frame including the transmitter module by loosening the retaining brackets at the top and bottom. Fasten the holding plate by screwing. Snap the frame with the top hanging cutouts into the intermediate frame including the transmitter module, with the rear marking 0 facing upwards. Hang the card guide in the top hanging cutouts of the frame and screw it into the holding plate at the bottom with the screw. Worn card guides can be easily replaced without having to change the transmitter module. Suitable actuators: The radio time relays for the card switches FZK14 and FZK61NP were developed specifically for control with the radio card switch FKF. A release delay and a response delay can be set for these switching relays. If heavier loads than those specified in the technical data are to be switched, the actuator must switch a contactor. In this case, do not activate the zero-crossing circuit on the FZK14. The radio module included in the radio card switch can be taught in encrypted form in the encryptable actuators of the 61 and 71 series listed below, as well as in the FAM14, in accordance with the operating instructions. The radio button encryption rocker FTVW is required for this. Encryptable actuators bear the pictogram. * If required, please order a 2-way frame R2E, 3-way frame R3E or 4-way frame R4E with hanging cutouts at the top.
| Property | Value |
| Protection class (IP): | IP20 |
| Radio frequency: | 868 MHz |
| Range: | 30 m |
| Number of commands: | 1 |
| Power supply: | other |
| Rolling code system: | no |
| Wireless button flush-mounted: | no |
| Wireless button on the surface: | yes |
| Keyboard protective cover: | no |
