Eltako 30067545 wireless pull switch FZS65-wg pure white glossy

Wireless pull switch for surface mounting 84x84x24mm or for mounting in the E-Design65 switch system*. With grey and red handle. Generates the energy for radio telegrams, therefore no connecting cable and no standby loss. Smart home sensor. When the handle is pulled and released, a radio telegram is sent to the Eltako building radio. The scope of delivery includes the fully assembled pull switch, an unprinted grey handle, a white printed red handle and two screws with dowels. Installation by screwing: First disassemble the fully assembled pull switch. To do this, remove the screw, unhook the cover and remove the intermediate frame including the rocker and transmitter module by loosening the retaining brackets at the top and bottom. Fasten the retaining plate by screwing on. Snap the frame with hanging cutouts at the top into the intermediate frame including the transmitter module and rocker, with the rear marking 0 facing upwards. Hang the cover with the cord through it into the upper hanging cutouts of the frame and screw it into the holding plate at the bottom with the screw. Shorten the cord to the desired length, push it through the red or gray handle and secure it with a double knot. Position-independent: The pull switch works in any position, even when attached to the ceiling. Suitable actuators: When activated, the wireless pull switch sends the same radio telegrams as a wireless button and can therefore be taught into actuators and the GFVS software like this. If it is taught into an actuator as an emergency call switch as central on, an emergency call can only be acknowledged using another taught-in button with central off. The radio module contained in the wireless pull switch can be taught in encrypted form into the encryptable actuators of the 61 and 71 series below, as well as into the FAM14, in accordance with the operating instructions. The wireless button encryption rocker FTVW is required for this. Encryptable actuators have the key pictogram. * If required, please order a 2-way frame R2E, 3-way frame R3E or 4-way frame R4E with hanging cutouts at the top.