Grothe transformers 'MADE IN GERMANY' Bell transformers are optimized for short-term use, such as those found in bells, gongs, chimes and door openers in residential areas, while safety transformers are designed for continuous use. Grothe bell and safety transformers are protected by a PTC, which switches off the transformer on the primary side in the event of a short circuit or overload. If the PTC is triggered by an overload or short circuit, the transformer should be switched off briefly, but at least for 1 minute, so that it can then be put back into operation. All transformers meet the highest environmental protection requirements, are tested according to EN61558 and have been validated. Product features: Installation in electrical distributors/flat distributors Short-circuit proof thanks to PTC Suitable for continuous loads Meet the highest environmental protection requirements Tested according to EN61558-2-6:2010 Validated, marked with ENEC symbol Technical data: Primary: 230V AC (50Hz) 90 x 90 x 55 mm (corresponds to 5 installation modules) Secondary: 12/16/24/32V AC (3.3/2.5/1.6/1.2A) Installation instructions: Note: Higher output voltage with low load or idle! depending on the selected output voltage, the secondary windings are to be connected in series or parallel with cable bridges (see type plate). After a short circuit, restart by briefly disconnecting the primary side from the mains. Accessory surface-mounted mounting set: incl. two cover caps for IP 20 Accessory surface-mounted mounting set: incl. fastening rail and material for surface-mounted mounting
| Property | Value |
| Type of transformer: | Safety transformer |
| Primary voltage: | 240 V |
| Width in pitch units: | 5 |
| Secondary voltage 1: | 12 V |
| Secondary voltage 2: | 16 V |
| Secondary voltage 3: | 24 V |
| Secondary current 1: | 3.3 A |
| Secondary current 2: | 2.5 A |
| Secondary current 3: | 1.6 A |
| Short circuit proof: | yes |
| Length: | 90 mm |
| Width: | 90 mm |
| Height: | 55 mm |
| Max. output power: | 40 W |
| Suitable for series installation: | yes |
| Temperature protection: | no |
| Max. output current: | 3.3 A |
| Max. power loss: | 7.5 W |
| With on/off switch: | no |
