Maico 0084.0129 Fan insert ER 100 RC

Version with radio receiver: On/off via radio switch DS RC or separate control RLS RC. Run-on time approx. 15 min only when switching off in individual operation with radio switch and deactivated DIN 18017-3 mode. The three speeds can be selected either on the radio switch or the control. Speed cannot be controlled. Can be combined with Wibutler Smart Home System. Radio-controlled fan with cover and filter for the MAICOsmart exhaust air system, with ISO Coarse > 30% (G2) filter and built-in 868 MHz radio receiver, based on EnOcean technology, for installation in flush-mounted housing. The fan can be installed in a master-slave network (RLS RC required). For one-room or two-room ventilation with a single fan. Three power levels 35 / 60 / 100 m3/h. Easy filter change without tools. Cover can be rotated by +- 5°, allowing compensation if the housing is installed at an angle. Simple and quick installation of the fan in the housing using the snap fastener and the electrical plug connection. Color: traffic white, similar to RAL 9016. All MAICO ER devices comply with protection class IP X5 and can therefore be installed in area 1 according to DIN0100-701, even with water jets. For details, see planning information. Protection class II. The extremely steep characteristic curve shows the high pressure capacity of the ER fans. Robust, energy-saving capacitor motor. Motor with thermal overload protection. Maintenance-free, with ball bearings closed on both sides. Volume flow characteristic curve and leakage air rate tested by TÜV Bayern eV Leakage air volume flow < 0.01 m3/h. Shaft level difference according to DIN 4109, tested by IAB Oberursel. With VDE mark. Can be combined with Wibuler Smart Home system. Motor: Energy-saving, robust capacitor motor with ball bearing, maintenance-free. Suitable for continuous operation. Safety note: The fan corresponds to protection class IP X5 and can therefore be installed in protection area 1 according to DIN0100-701, even in the presence of jet water. For details see planning information chapter Single-pipe ventilation according to DIN 18017-3. Article: ER 100 RC, Design: Radio receiver, Delivery volume: 35 m3/h / 60 m3/h / 100 m3/h, Speed: 850 1/min / 1250 1/min / 1900 1/min, Air direction: Extract air, Speed controllable: no, SEC average: -6.72 kWh/(m2*a), Voltage type: Alternating current, Rated voltage: 230 V, Mains frequency: 50 Hz, Power consumption: 10 W / 21 W / 29.5 W, IMax: 0.1 A / 0.12 A / 0.14 A, Protection class: IP X5, Mains cable: 3 / 1.5 mm2, Installation location: Wall / ceiling, Installation type: Flush-mounted, Installation position: vertical / horizontal, System type: decentralized, material: plastic, color: traffic white, similar to RAL 9016, weight: 1.5 kg, weight with packaging: 1.8 kg, filter class: ISO Coarse > 30% (G2), width: 250 mm, height: 250 mm, depth: 138 mm, width with packaging: 280 mm, height with packaging: 280 mm, depth with packaging: 150 mm, conveying medium temperature at IMax: 40 °C, ambient temperature: -10 °C to 40 °C, sound pressure level: 27 dB(A) / 36 dB(A) / 45 dB(A) / specification according to DIN 18017-3 with an equivalent absorption area AL = 10 m2, nominal width: 75 mm / 80 mm