Maico 0084.0134 Fan insert ER 100 H

Version with humidity control and base load switching: Barrier-free product, as automatic switching on/off is possible via humidity control. Fully automatic intelligent humidity control. No setting of the switch-on humidity necessary. Fan monitors the room humidity independently and ventilates automatically. Not speed controllable. Not suitable for second room ventilation. Manual operation via a switch is possible, e.g. switching on full load via light switch. Standard switching: Fan runs in base load mode, humidity control is active, full load operation when the switch-on point is exceeded, base load operation when the switch-off point is undershot. Other switching variants: Fan operation with or without base load mode, manual switching on of full load, switching the fan on or off via a switch. Switching on of full load via the light switch and associated run-on control (run-on time 15 min) of the fan. The fan runs until the humidity in the room has fallen below the switch-off humidity. After 60 min at the latest, the run-on time is activated and the fan is then switched off. Fan with cover and ISO Coarse > 30% (G2) filter for installation in flush-mounted housing. For one-room or two-room ventilation with a single fan (exception: version H). Easy filter change without tools. Cover can be rotated by +- 5°, allowing compensation if the housing is installed at an angle. Simple and quick installation of the fan in the housing using the snap fastener and the electrical plug connection. Color: traffic white, similar to RAL 9016. All MAICO ER devices comply with protection class IP X5 and can therefore be installed in area 1 according to DIN0100-701, even with water jets. See planning information for details. Protection class II. The extremely steep characteristic curve shows the high pressure capacity of the ER fans. Robust energy-saving capacitor motor. Motor with thermal overload protection. Maintenance-free, with ball bearings closed on both sides. Volume flow characteristic curve and leakage air rate tested by TÜV Bayern eV Leakage air volume flow < 0.01 m3/h. Shaft level difference according to DIN 4109, tested by IAB Oberursel. With VDE mark. Article: ER 100 H, Design: Humidity control, Delivery volume: 35 m3/h / 101 m3/h, Speed: 850 1/min / 1900 1/min, Air direction: Ventilation, Speed controllable: no, SEC average: -21.95 kWh/(m2*a), Voltage type: Alternating current, Rated voltage: 230 V, Mains frequency: 50 Hz, Power consumption: 9 W / 29.5 W, IMax: 0.09 A / 0.14 A, Protection class: IP X5, Mains cable: 5 / 1.5 mm2, Installation location: Wall / ceiling, Installation type: Flush-mounted, System type: decentralized, Material: Plastic, Color: traffic white, similar to RAL 9016, Weight: 1.485 kg, Weight with packaging: 1.77 kg, Filter class: ISO Coarse > 30% (G2), blow-out direction: side, width: 250 mm, height: 250 mm, depth: 150 mm, width with packaging: 280 mm, height with packaging: 280 mm, depth with packaging: 155 mm, conveying medium temperature at IMax: 40 °C, run-on time: 6 min / run-on time available when using an optional switch (e.g. light switch), sound pressure level: 26 dB(A) / 45 dB(A) / specification according to DIN 18017-3 with an equivalent absorption area AL = 10 m2, nominal width: 75 mm / 80 mm