Maico 0086.0206 Exhaust air system ZEG2 EC

Central ventilation device. For simultaneous ventilation of several rooms in single-family homes or apartments. Protection class IP 20. Housing is easy to clean. The device is equipped with a quiet and energy-efficient EC motor. With 5 possible exhaust air connections (3 x DN 125, 1 x DN 125/DN 160) and 1 x DN 160 = predetermined breaking point), with an exhaust air connection DN 125. Motor and electronics are integrated. A maximum of 28 speed levels are possible. Preset as standard to levels 1(a*) = Low, 3(a*) = Normal and 11 (a*) = High. The preset speed levels can be easily changed using so-called DIP switches. With integrated humidity sensor for automatic humidity-dependent control. Wireless remote control ZEG2 EC-FB included in delivery. * = there is characteristic curve a and characteristic curve b, depending on the setting of DIP switch 7. Control: Wireless remote control ZEG2 EC-FB with humidity sensor control and 6 setting buttons (humidity sensor is included in the ZEG2 EC). Radio frequency 868.3 MHz. Dimensions (HxWxD): 83x80x28 mm. Protection class: IP 30. Status display via LED. Settings, Away mode (energy saving mode), Automatic mode regulates ventilation level according to the determined humidity sensor measurements, Timer mode (15/30/60 minutes) in High level - then back to last selected level, 1. Low speed - standard position at night, 2. Normal speed - standard position during the day, 3. High speed - when cooking and showering, About automatic mode: In this position the extractor unit runs at low speed until a significant increase in the relative humidity in the extract air is measured within 3 minutes (adjustable 5% or 10% with DIP switch 7). The unit then switches from Low level (1) to Normal (2) or High (3) depending on the setting of DIP switch 7. If a drop in humidity is detected, the ZEG2 EC runs for 15 or 30 minutes in Normal or High level (run-on time adjustable with DIP switch 8). The unit then switches back to Low level. For absence mode: The ZEG2 EC runs in energy saving mode and does not react to the humidity sensor. Installation instructions: The ZEG2 EC-FB remote control can be installed in damp rooms, but not directly in the shower cubicle. No splash water may come into contact with the remote control (relative humidity max. 90%). The ZEG2 EC device must be installed in a dry room and must not come into contact with splash water (relative humidity max. 90%). Electrical connection: Flexible connection cable approx. 1.2 m long. Article: ZEG2 EC, Delivery volume: 535 m3/h / 600 m3/h / system pressure at 200 Pa or system pressure at 100 Pa, Speed controllable: yes, SEC average: -20.6 kWh/(m2*a), Energy efficiency class: D, Voltage type: Alternating current, Rated voltage: 230 V, Mains frequency: 50 Hz, Power consumption: 2 W - 85 W, IMax: 0.05 A - 0.8 A, Protection class: IP 20, Installation location: Basement / storage room / knee wall / utility room / boiler room / technical room, Installation position: vertical / horizontal, System type: central, Material: plastic, Color: white, Weight: 4.586 kg, Weight with packaging: 5.14 kg, Connection diameter: 125 mm, Width: 443 mm, Height: 463 mm, depth: 303 mm, width with packaging: 455 mm, height with packaging: 485 mm, depth with packaging: 315 mm, DC motor: true, max. speed: 3200 1/min, heat recovery via: without