Through-hole anchor, including galvanized nut and galvanized large washer. For use in functional maintenance please observe additional regulations! Maximum permissible loads (the partial safety factors for the resistances specified in the approval as well as a partial safety factor of Y (F) = 1.4 are taken into account. When combining tensile and shear loads, edge influences and anchor groups, please observe design method A (ETAG Appendix C) ) of an anchor in normal concrete C20/25 (the concrete is assumed to be normally reinforced; with higher concrete strengths, values up to 55% higher are possible). The entire approval certificate ETA-05/0069 must be observed when designing. For outdoor areas we recommend stainless steel anchors! . Technical specifications: . Effective anchoring depth h (ef): 45 mm . Permissible centric tensile load of a single anchor without edge influence N (zul) (ie for tensile load - edge distance c = 1.5 h (ef) and axial distance s = 3 h (ef) or for shear load - edge distance c = 10 h (ef) and axial distance s = 3 h (ef) ) Cracked concrete C20/25 : 2.4 kN Non-cracked concrete C20/25 : 4.3 kN . Permissible shear force of a single anchor without edge influence V (zul) (ie for tensile load - edge distance c = 1.5 h (ef) and axial distance s = 3 h (ef) or for shear load - edge distance c = 10 h (ef) and axial distance s = 3 h (ef) ) Cracked and non-cracked concrete C20/25 : 6.9 kN . Permissible bending moment (M (d) ) M (zul) : 14.9 Nm . Component dimensions and installation parameters (The values in brackets only apply to non-cracked concrete) : Standard component thickness (= 2 xh (ef) ) h (min.1) : 100 mm Minimum centre distance s (min) : 35 (40) mm Minimum centre distance for c = : 50 mm Minimum edge distance c (min) : 40 mm Minimum edge distance for s = : 70 (100) mm . Reduced component thickness (< 2 xh (ef) ) h (min.2) : 80 mm Minimum center distance s (min) : 35 mm Minimum center distance for c = : 70 mm Minimum edge distance c (min) : 40 mm Minimum edge distance for s = : 100 mm Nominal bore diameter d (0) : 8
| Property | Value |
| Length: | 75.00 mm |
| Bore hole depth: | 75.00 mm |
| Bore hole diameter: | 8.00 mm |
| Version: | Expansion dowel |
| Material: | Steel |
| With screw: | yes |
| Suitable for screw diameter: | 8 mm |
| Suitable for aerated concrete: | no |
| With edge: | no |
| Material quality: | other |
| Suitable for fastening with cable ties: | no |
| Suitable for Hexagon wood screw: | no |
