For laying pipes and cables - in conjunction with the EC Euro-Clip system - using firing devices, the two rings of the ESP are adapted to the firing devices from Hilti (GX 120-ME), Spit (PULSA 700 E) and Würth, clip the EC Euroclip onto the ESP, then press the ESP onto the firing shaft, align it by hand and fire. The notches on the ESP allow easy alignment, the EC clamp can be realigned and lined up if necessary, if several pipes are to be attached later, clip the EC into the ESP and then line them up with the already mounted EC Euro clips, the ESP is now already in the right position and only needs to be fired, the flat design of the firing plate means that it disappears under the pipe and is almost invisible after assembly, the ESP can be clamped onto the muzzle of the Hilti, Spit and Würth firing pistols and therefore does not need to be held separately. With just one ESP, several EC Euro clips can be attached, thanks to the 2 mm diameter of the hole, even an incompletely driven nail will clamp and the ESP will not wobble, use of a cable tie (as with the ESD Euro plug dowel) is possible. There is a ramp on the side of the ring so that the cable tie can be inserted from both sides without any problems, light grey, halogen-free, PA 6, UV-stabilised, temperature range: -20 degrees C to +85 degrees C, silicone-free
